最近有车友咨询关于：“油改气”汽车可能会出现启动困难的故障，为此，下面是济南汽车油改气整理的原因，希望对大家有所帮助。首先我们先一步步的分析，汽车发动机正常启动需要必备三个要素：火花、压 缩和正常比例混合气。
If you have recently had a consultation about: "oil to gas" car may start the difficult problems, therefore, the following is arranging the reasons, jinan car oil to gas hope to be of help. First we analysis step by step, the car engine normal boot need three elements: the necessary spark, pressure reduction, and normal mixture proportion.
1.检查油路，首先打开钥匙门仪表灯亮的档，同时能瞬间听到油泵的转 动，如果没有声音，拧下油泵的高压油管看看高压油管的压力多少，如果里 面油压达到一定 的时侯，油泵不会工作，要是油管里没油，在查看通往油箱 里的油泵的火线以及打铁线是不是有故障，要是有故障说明电路有毛病，如 果通电正常，则是油泵故障。
1. Check the oil, the first key to open the door of instrument lights, can instantly hear pump turn move at the same time, if there is no voice, screw pump under high-pressure tubing look at how much pressure is on high pressure tubing, if in the face of oil pressure reaches a certain time, the pump will not work, if there was no oil in the tubing, in view of the oil pump to the tank wire and iron wire is defective, if there is fault that there is something wrong with, if electricity is normal, is the oil pump failure.
2.检查缸线是否有电，检查方法一，济南汽车油改气用专用的仪表测量四否有电，跳火 的强度能不能达到车辆正常着火的限度，方法二，用单缸跳火法，逐次将各 个缸进行跳火试 验，用眼睛观看跳火状况，在第二种方法中注意带上绝缘手 套进行操作，防止电伤，因为到压线在跳火的时候瞬间强度能达到18KV上下 。所以注意电伤。
2. To check whether there is electric cylinder line, an inspection method, jinan car oil to gas four no electricity, use special instrument to measure the intensity of the flame can reach the limits of normal vehicles on fire, method 2, with a single cylinder method, successive will each cylinder to jump fire tests, with his eyes to watch fire situation, pay attention to in the second method with insulation hand set, to prevent electrical injury, because the line pressing in flame instantaneous strength can reach 18 kv up and down. So pay attention to electrical injury.
