Recently, as fuel prices continued to rise, also improve vehicle running costs. In order to further reduce vehicle use cost, comprehensive energy conservation and emissions reduction work.
公务用车通过改用“煤层气”作为燃料后，燃料费用降低了近一半，而且更为清洁环保，有效的降低了二氧化碳排放量。今后，高速公司将进一步完善加气制度及其他各项管理制度，并逐步对其他符合条件的生产性车辆进行“油改气”，在降低汽车尾气排放、改善大气环境的同时,进一步降低运行成本。
Official cars through the switch to "CBM" as a fuel, fuel costs fell by nearly half, and more clean and environmental protection, effectively reduce the emissions of carbon dioxide. In the future, the company will further improve the system of gas, and other various management systems, and gradually to other eligible production vehicles "oil to gas", to reduce vehicle emissions and improve the atmospheric environment at the same time, further reduce the running cost.
汽车改装天然气（油改气）后应根据实际情况对车的用气量做出调整。今天，托马油改气就来为您解答。修车的都知道：汽油机的空燃比是1：14.7 用天然气一样需要一个合适的混合气比例（进入发动机空气和天然气的比例）。一般情况下,新车改装天然气一般是没多少要调节的。但是旧车就不一样了，各个工况都不是很好，这时，就要根据情况改变CNG的进气量和怠速进气量。
Car modification of gas oil (gas) should be according to the actual situation after gas in the car to adjust. Today, toma oil to gas is to answer for you. Repair all know: gasoline engine air-fuel ratio is 1:14. 7 in the same way as a natural gas needs a proper mixture ratio (enter the proportion of air and gas) engine. In general, new car modified natural gas is usually not much to adjust. But the old car is different, every working condition is not very good, then, will change according to the circumstance of CNG air inflow and idle air inflow.
天然气汽车（油改气车辆）启动困难有众多因素，有可能是原厂车故障，也有可能是有汽车的原厂车故障也有可能是油改气操作不当所致，所以，建议广大车友在进行汽车油改气前，一定要到正规厂家改装，哪些因素导致油改气车辆启动难。
Natural gas vehicle (oil to gas vehicles) start difficult there are many factors, it is possible that original vehicle fault, it is possible that a car factory car trouble now it is possible that the oil gas caused by improper operation, therefore, suggest the cyclists in front of the car oil to gas, must be converted into normal manufacturer, what factors lead to problems in terms of oil to gas vehicle launch.
汽车发动机正常启动需要必备三个要素：火花、压缩和正常比例混合气。
Automobile engine normal boot needs three elements: the necessary spark, compression and normal mixture ratios.
1.检查缸线是否有电，检查方法一，用专用的仪表测量四否有电，跳火的强度能不能达到车辆正常着火的限度，方法二，用单缸跳火法，逐次将各个缸进行跳火试 验，用眼睛观看跳火状况，在第二种方法中注意带上绝缘手套进行操作，防止电伤，因为到压线在跳火的时候瞬间强度能达到18KV上下。所以注意电伤。
1. To check whether there is electric cylinder line, an inspection method, four no electricity, use special instrument to measure the intensity of the flame can reach the limits of normal vehicles on fire, method 2, with a single cylinder method, successive to the cylinder for fire tests, with his eyes to watch fire situation, pay attention to in the second method with insulating gloves, prevent electrical injury, because the line pressing in flame instantaneous strength can reach 18 kv up and down. So pay attention to electrical injury.
2.检查油路，首先打开钥匙门仪表灯亮的档，同时能瞬间听到油泵的转动，如果没有声音，拧下油泵的高压油管看看高压油管的压力多少，济南汽车油改气如果里面油压达到一定 的时侯，油泵不会工作，要是油管里没油，在查看通往油箱里的油泵的火线以及打铁线是不是有故障，要是有故障说明电路有毛病，如果通电正常，则是油泵故障。
2. Check the oil, the first key to open the door of instrument lights, can instantly hear the rotation of the pump at the same time, if there is no voice, screw pump under high pressure tubing and see how much pressure, high-pressure oil pipeline jinan car oil to gas inside if oil pressure reaches a certain time, the pump will not work, if there was no oil in the tubing, in view of the oil pump to the tank wire and iron wire is defective, if there is fault that there is something wrong with, if electricity is normal, is the oil pump failure.
