汽车油改气天然气钢瓶必须保持机密部分,站到固定安全;气瓶远离热源,避免接触和强烈振动;一般储存钢瓶数量不得超过两瓶在实验室。压力测试日期和发送检验日期气瓶体积重量下次为了避免混淆当使用各种缸,经常会画上不同的颜色,显示名称的气瓶内气体瓶。
Ji'nan automotive gas oil natural gas cylinders must be kept confidential part, stand to the fixed safety; gas cylinders away from heat, avoid contact with strong vibration; general store cylinders shall not exceed two bottles in the laboratory. Pressure test date and send the inspection date vessel volume weight next to avoid confusion when using various cylinder, often painted in different colors, the name of the gas bottle cylinder display.
济南汽车油改气天然气钢瓶减压器来分类,选择安装螺丝收紧,防止泄漏;减压器和开关阀门打开和关闭和动作必须缓慢;使用时,应该首先把开关阀,打开之后减压器;完成后,关掉开关阀,把更多的空气,并关闭减压器。不仅必须关闭减压器,没有一个开关阀。
Ji'nan automotive gas oil cylinder pressure relief device of gas to classification, choose to install screws tighten, prevent leakage; regulator and switching the valves open and close and action must be slow; when in use, should first put the valve open, after the pressure reducer; turn off the valve, after completion, the more air, and turn off the regulator. Not only must close the regulator, not a switch valve.
当使用天然气钢瓶,操作者应站在位置的垂直于缸出口。操作是禁止把影响,并且定期检查空气泄漏,压力表读数应注意。
When using natural gas cylinders, the operator should stand in the position of the perpendicular to the cylinder outlet. The influence of operation is prohibited, and regularly check the air leakage, pressure gauge reading should pay attention to.
氧气和氢气瓶等,应配备专用工具,严禁接触石油。运营商不能衣服沾有油脂或易感应该产生静电手套操作服装,以免引起燃烧或爆炸。
Oxygen and hydrogen gas, should be equipped with special tools, forbidden access to oil. Operators should not clothes stained with grease or susceptibility should produce electrostatic gloves clothing, so as not to cause fire or explosion.
汽车油改气可燃气体和助燃气体钢瓶,火焰的距离应大于10米,它是难以实现的,可以采取隔离措施)。
automotive oil to gas, combustible gas and combustion supporting gas cylinders, the flame of the distance should be greater than 10 meters, it is difficult to achieve, can take isolation measures).
气瓶使用后,应按规定超过0.05 MPa残余应力。可燃气体应该0.2 MPa到0.3 MPa(约2公斤/厘米2 ~ 3公斤/平方厘米计压力)H2应保留2 MPa,以防对充气危险,不要耗尽后使用。
对于技术定期检查。填充一般气瓶测试三年;如发现在使用严重腐蚀或损坏,应提前测试。
